La CornueRepair Miami

Broward · South Florida

La Cornue repair in Weston

Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.

We cover Weston and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.

By unit

Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.

  • A heavy hand-built enameled range cooker photographed low from its front left corner in a bright cream kitchen, the deep colored enamel of the flank filling the left of the frame, a brass rail and a row of round brass knobs running away from the camera, two oven doors below, adjustable feet on a warm oak floor.
    Dual fuel · gas · all-induction — Château, Châtelet, Castel, Grand Palais, CornuFé

    La Cornue range repair in Weston

    The range is what La Cornue makes, and everything else in the line exists around it. A Château is built to order in France, arrives in a crate weighing over half a ton, and is assembled from parts a customer chose one at a time: which oven is gas and which is electric, whether the top carries a French top, a lava-rock grill, induction or a teppanyaki plate, which of about fifty enamels, which trim metal. Two of them are almost never identical. That is the first thing a repair on one has to take seriously — the model number tells you the size, and the configuration code tells you what is actually under the lids.

    • Dual fuel, all gas or all induction — three different ranges, three parts lists
    • The configuration code, not just the model, decides what is on the top
    • Made-to-order enamel and trim are part of the job, not an extra
    Range repair
  • A tall electric wall oven built into a run of warm oak cabinetry, its door standing fully open on an empty cavity with a circular fan grille on the back wall and three wire shelf runners either side.
    Vaulted ovens and convection ovens — gas, electric, and the Tourelle wall oven

    La Cornue oven repair in Weston

    There are three different ovens on this make and they fail in three different ways. The vaulted gas oven cooks by radiant heat inside a sealed dome and has an electric broiler over it. The vaulted electric oven sits on the other side of the same range. And since 2025 there is a standalone one: the Château Tourelle, a fully electric multifunction wall oven in 60 and 75 centimeter widths, built to sit in a cabinet run next to a Château cooktop. Which of the three you have decides everything about the repair.

    • Vaulted gas, vaulted electric and the electric Tourelle wall oven
    • Gas ovens carry an electric broiler — browning and baking can fail separately
    • Thermostat drift is measured against a probe, never adjusted by feel
    Oven repair
  • A gas cooking surface with four open brass burner crowns set into a pale limestone island, photographed at a low three-quarter angle so the island runs away to the right and a bright cream kitchen is soft behind it.
    Brass gas burners · plaque coup de feu · lava-rock grill · induction · teppanyaki

    La Cornue cooktop repair in Weston

    A La Cornue cooktop is a set of modules chosen at order time and dropped into a stainless frame: brass gas burners at 17,000 and 7,500 BTU, a 22,000 BTU power burner, the cast-iron plaque coup de feu heated by a single burner underneath, a lava-rock grill, ceramic-glass induction zones, an electric teppanyaki plate. This is the top of a range, and each module is a different repair. Sold on its own without ovens beneath it, the same top is a rangetop, and it has its own page.

    • Gas, induction, French top, grill and teppanyaki modules on one frame
    • Induction is the only half of this line that shows a code — E2, U400, Er
    • A cracked glass hob is disconnected first and diagnosed second
    Cooktop repair
  • A wide stainless cooking top dropped into a counter run photographed square on from the front, so that what is beneath it is plain: two banks of oak drawers and a cupboard door, and no oven at all.
    T40 to T48 · 200 mm into the counter · the same modules, no ovens beneath

    La Cornue rangetop repair in Weston

    A rangetop is the top half of a La Cornue sold in its own right: the same brass burners, the same plaque coup de feu, the same grill, induction and teppanyaki modules, in a stainless frame 200 mm deep that drops into a counter with nothing underneath it. T40 through T48, from 600 to 1800 mm wide. Every cooktop repair applies to it and no oven repair does — which makes it the simplest appliance in the line and the one most often confused with the range on a booking.

    • T40 to T48 — the same configuration codes as the range
    • No ovens, no oven thermostats, no door seals
    • Much lighter than a range, so the one job that prices weight rarely applies
    Rangetop repair
  • A tall chimney flue running from the top of a hood up a pale plastered wall to the ceiling, photographed square on from a little way back in bright daylight, the canopy itself cut off at the bottom of the frame.
    Château motorized hoods H11–H20 · island hoods · inserts · CornuFé Cascade, Euclid, Loge, Marquee

    La Cornue range hood repair in Weston

    The hood over a La Cornue is not an accessory bought to match. A motorized Château hood starts at $17,400 for the 90 and runs past $25,000 for the Grand Palais 180, it is made in the same enamels and trims as the range, and it does real work: a 600 CFM blower on a four-speed variable motor, baffle filters with a grease capture system, three 20-watt lights and a remote. When one stops, the kitchen it was built for stops working properly.

    • Motorized Château hoods, island hoods and inserts, plus the CornuFé collection
    • 600 CFM blower, four-speed variable motor, baffle filters, remote control
    • A hood is finished to match the range — the enamel is part of the repair
    Range hood repair

By job

Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.

  • An open-ended spanner on the thermocouple nut at the back of a brass gas valve body, seen behind the removed front rail of a range with the valve manifold exposed along the frame.
    from $265

    Gas valve and thermocouple repair

    The safety chain: a valve that will not hold open, a thermocouple that no longer tells it to, a knob that has gone stiff or will not shut off cleanly. This is the part of a gas range where nothing gets improvised and nothing gets left half-diagnosed.

    • Safety valve and flame supervision tested as a system
    • Stiff or leaking knob valves rebuilt or replaced, never lubricated over
    • Leak-checked at every joint that was opened
    What this involves
  • A cracked black ceramic panel being lifted on suction handles clear of a limestone counter cutout, the frame and coils visible in the opening below it.
    from $595

    Induction glass replacement

    The one problem on this make with a safety instruction attached. La Cornue's guide is unambiguous: a cracked hob is disconnected from the power supply immediately and not used until it has been repaired, because the glass is what separates the coils and the electronics from whatever is spilled on it.

    • Made safe first, diagnosed second
    • Glass ordered to the range's own configuration, not a generic panel
    • Coils and electronics inspected for what has already got through the crack
    What this involves
  • A tiny brass orifice held in fine tweezers directly over an open burner well, a nut driver and a second orifice lying on the steel top beside it.
    from $325

    Propane conversion service

    La Cornue publishes a conversion procedure and a specific parts set for the CornuFé 90 and 110, and specifies fuel at order time on a Château. A conversion done with approximate parts gives yellow flames, soot and burners that will not hold a simmer — and it is one of the most common things we undo on a range that has changed house or fuel.

    • The maker's own orifice set, not a universal kit
    • Every burner and both ovens set and verified, not just the fronts
    • Written record of what the range is now set for
    What this involves
  • Four steel baffle filters standing on edge in a sink of hot soapy water, grease lifting off them into the foam, the empty hood canopy visible out of focus above and behind.
    from $175

    Hood filter and duct service

    Faded suction with a motor that still sounds fine is almost never the motor. Baffle filters with a grease capture system are dishwasher safe, and the 600 CFM figure is specified against an unobstructed six-inch duct — eight on the inserts. Most of this job is the air path.

    • Baffles cleaned or replaced first, because it costs nothing to rule out
    • Duct run, damper and termination measured rather than assumed
    • Airflow verified after the work, not promised
    What this involves
  • A gloved hand seating a small ceramic igniter onto its bracket at the back of the floor of an arched oven cavity, lit only by a torch held out of frame.
    from $275

    Vaulted gas oven ignition repair

    The vaulted gas oven has no display, no window and no error code — La Cornue's own Château guide contains no troubleshooting section at all. So an oven that will not light is diagnosed the way gas has always been diagnosed: igniter, safety valve, thermocouple, supply, in that order and with instruments.

    • A glowing igniter that never opens the valve is the classic failure here
    • Safety valve and flame supervision measured rather than swapped
    • Same-day priority — an oven that smells of gas is not a next-week call
    What this involves
  • Brass burner caps and crowns lifted off and laid out in a neat row on a white cloth on a limestone counter beside the range, with a small brass brush and a port pick beside them.
    from $195

    Appliance maintenance

    An annual visit that exists because most of what goes wrong on this make goes wrong slowly. Burners drift rich, thermostats drift hot, baffles saturate, brass tarnishes, and the owner adapts to every one of them without noticing. This is the visit that measures instead of adapting.

    • Burner combustion and oven calibration checked against specification
    • Baffle filters, duct flow and blower condition on the hood
    • Enamel, trim and seals inspected while they are still repairable
    What this involves

Nearby

Where else we work near Weston

Every place below has its own page, with what the equipment and the access are like there.

In more detail

La Cornue repair in Weston, in more detail

What La Cornue equipment is like in Weston

Planned neighborhoods where whole phases share a specification, so we usually know the unit before we arrive. Most are now well past their original coverage.

Weston sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are La Cornue work — cooktops and rangetops, ovens, range hoods — and both are diagnosed on site before anything is priced.

Heat, grease and power cuts — what they do to burners and vents

Inland it is heat and grease rather than salt. A range in a kitchen that runs air conditioning for nine months of the year lives in a hotter cabinet than its designer assumed, and grease that condenses in a hood liner instead of leaving through it comes back as a fan that labors and a filter that no longer filters. In Weston most of what we are called out to is a burner, an igniter or a control that has been asked to work in that for years.

What that means for the appliances in Weston

  • Whole streets here were built to one specification, so we frequently know the model before we arrive and can bring what it usually needs on the first visit.

How a visit in Weston is arranged

We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.

  • How the appliance is built in, and whether it has ever been pulled out before
  • Whether there is a second one — a bar, a pantry, a garage or an outdoor kitchen
  • Whether the gas is propane or natural, which decides the orifices and the parts that ride in the van
  • The diagnosis first, then the scope and the price in writing, and your approval before anything is opened

What it costs, and what moves the figure

Prices in Weston are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.

The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.

Before you book

Questions about a visit in Weston

Do you cover Weston?

Yes. Weston is in Broward County and inside the area we work every week. Give us the address when you book, and say how the La Cornue is installed — what has to come apart to reach it matters as much as where it is.

How soon can you get to Weston?

We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.

Does it cost more because the job is in Weston?

No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.

What do you need from me before the visit in Weston?

The model number from the data plate, a photograph of the display if anything is showing on it, and a line about what the unit is doing. Those three decide which parts a technician brings, and they are the difference between one visit and two.

Booking a visit in Weston

Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.

This article is based on:

  • Official manufacturer documentation
  • Internal repair procedures
  • Technician repair history
  • Company quality standards
Call (305) 614-3699