Broward · South Florida
La Cornue repair in Hollywood
From bungalows near the beach to newer buildings inland, with the salt exposure dropping off the further west you are. It changes what we check first.
We cover Hollywood and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Hollywood, by La Cornue unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
Dual fuel · gas · all-induction — Château, Châtelet, Castel, Grand Palais, CornuFé La Cornue range repair in Hollywood
The range is what La Cornue makes, and everything else in the line exists around it. A Château is built to order in France, arrives in a crate weighing over half a ton, and is assembled from parts a customer chose one at a time: which oven is gas and which is electric, whether the top carries a French top, a lava-rock grill, induction or a teppanyaki plate, which of about fifty enamels, which trim metal. Two of them are almost never identical. That is the first thing a repair on one has to take seriously — the model number tells you the size, and the configuration code tells you what is actually under the lids.
- Dual fuel, all gas or all induction — three different ranges, three parts lists
- The configuration code, not just the model, decides what is on the top
- Made-to-order enamel and trim are part of the job, not an extra
-
Vaulted ovens and convection ovens — gas, electric, and the Tourelle wall oven La Cornue oven repair in Hollywood
There are three different ovens on this make and they fail in three different ways. The vaulted gas oven cooks by radiant heat inside a sealed dome and has an electric broiler over it. The vaulted electric oven sits on the other side of the same range. And since 2025 there is a standalone one: the Château Tourelle, a fully electric multifunction wall oven in 60 and 75 centimeter widths, built to sit in a cabinet run next to a Château cooktop. Which of the three you have decides everything about the repair.
- Vaulted gas, vaulted electric and the electric Tourelle wall oven
- Gas ovens carry an electric broiler — browning and baking can fail separately
- Thermostat drift is measured against a probe, never adjusted by feel
-
Brass gas burners · plaque coup de feu · lava-rock grill · induction · teppanyaki La Cornue cooktop repair in Hollywood
A La Cornue cooktop is a set of modules chosen at order time and dropped into a stainless frame: brass gas burners at 17,000 and 7,500 BTU, a 22,000 BTU power burner, the cast-iron plaque coup de feu heated by a single burner underneath, a lava-rock grill, ceramic-glass induction zones, an electric teppanyaki plate. This is the top of a range, and each module is a different repair. Sold on its own without ovens beneath it, the same top is a rangetop, and it has its own page.
- Gas, induction, French top, grill and teppanyaki modules on one frame
- Induction is the only half of this line that shows a code — E2, U400, Er
- A cracked glass hob is disconnected first and diagnosed second
-
T40 to T48 · 200 mm into the counter · the same modules, no ovens beneath La Cornue rangetop repair in Hollywood
A rangetop is the top half of a La Cornue sold in its own right: the same brass burners, the same plaque coup de feu, the same grill, induction and teppanyaki modules, in a stainless frame 200 mm deep that drops into a counter with nothing underneath it. T40 through T48, from 600 to 1800 mm wide. Every cooktop repair applies to it and no oven repair does — which makes it the simplest appliance in the line and the one most often confused with the range on a booking.
- T40 to T48 — the same configuration codes as the range
- No ovens, no oven thermostats, no door seals
- Much lighter than a range, so the one job that prices weight rarely applies
-
Château motorized hoods H11–H20 · island hoods · inserts · CornuFé Cascade, Euclid, Loge, Marquee La Cornue range hood repair in Hollywood
The hood over a La Cornue is not an accessory bought to match. A motorized Château hood starts at $17,400 for the 90 and runs past $25,000 for the Grand Palais 180, it is made in the same enamels and trims as the range, and it does real work: a 600 CFM blower on a four-speed variable motor, baffle filters with a grease capture system, three 20-watt lights and a remote. When one stops, the kitchen it was built for stops working properly.
- Motorized Château hoods, island hoods and inserts, plus the CornuFé collection
- 600 CFM blower, four-speed variable motor, baffle filters, remote control
- A hood is finished to match the range — the enamel is part of the repair
By job
The repairs we are called out for in Hollywood
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $255 Oven element and broiler replacement
Every vaulted gas oven on this make carries an electric broiler above it, and the electric ovens are elements throughout. That means a range can lose browning and keep baking perfectly, or the reverse, and the two are separate parts.
- Bake and broil are separate circuits and separate failures
- Elements measured cold and under load
- Element supports and terminals checked, because that is where they burn out
-
from $235 Convection fan repair
The electric and multifunction ovens use a fan, and the noise it makes changes as the oven heats — which the manual says is normal. A fan that rumbles, ticks, slows or stops is not normal, and it takes the oven's evenness with it.
- Bearing noise separated from the normal change in note
- Motor tested at temperature, because that is when it fails
- Blade and housing checked for the contact that causes ticking
-
from $295 Cooktop control and wiring repair
U400 latched on the display, a hob with no display at all, a fuse or residual-current device that trips repeatedly. All three are supply-and-connection problems in the maker's own words, and all three turn up after something in the house changed.
- The appliance connection checked against the maker's specification
- Over-voltage and lost supply distinguished from a dead control
- Findings written down when the problem is upstream of the range
-
from $175 Hood filter and duct service
Faded suction with a motor that still sounds fine is almost never the motor. Baffle filters with a grease capture system are dishwasher safe, and the 600 CFM figure is specified against an unobstructed six-inch duct — eight on the inserts. Most of this job is the air path.
- Baffles cleaned or replaced first, because it costs nothing to rule out
- Duct run, damper and termination measured rather than assumed
- Airflow verified after the work, not promised
-
from $95 Diagnostic visit
One visit, one technician, one answer in writing. On a make with three error codes in its entire documentation, the diagnostic is not a formality before the repair — it is the repair's only source of information, and it is done with instruments rather than by elimination.
- Measured, not guessed — this make reports almost nothing on its own
- The configuration code read off the range, because it decides the parts
- Written findings and a from-price before anything is opened
-
from $155 Surface burner and igniter service
Clicking with no flame, a burner that lights and will not stay lit, a lazy yellow flame. On brass burners in a coastal kitchen these are three symptoms of a short list of causes, and none of them is the ignition module when only one burner is affected.
- One burner out is the electrode or the ports — not the module
- Yellow flame is air mix, fuel or an orifice, and it is measurable
- Ports cleared properly rather than poked at
Nearby
Where else we work near Hollywood
Every place below has its own page, with what the equipment and the access are like there.
Neighborhoods in Hollywood
Elsewhere in Broward
In more detail
La Cornue repair in Hollywood, in more detail
What La Cornue equipment is like in Hollywood
From bungalows near the beach to newer buildings inland, with the salt exposure dropping off the further west you are. It changes what we check first.
Hollywood sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are La Cornue work — cooktops and rangetops, ovens, range hoods — and both are diagnosed on site before anything is priced.
Salt, heat and storms — what they do to burners and vents
Close to the water it is the steel and the ignition that go first. Salt reaches burner caps, grates and igniter electrodes, and an igniter that has to spark through corrosion is an igniter that clicks and does not light. Ventilation suffers with it: a hood that pulls salt air through its motor every day is on a shorter life than the one the manufacturer costed. In Hollywood that is the difference between an annual clean and a seasonal one.
What that means for the appliances in Hollywood
- Range hoods — Almost nothing in a tower vents outside, so the hood recirculates and lives entirely on a charcoal filter — a consumable most owners have never been told about, and the reason a healthy-sounding hood can move nothing at all.
- Cooktops and rangetops — Induction is common in these buildings because a gas line often is not, and an induction top under a counter needs the ventilation gap the instructions specify — which a full drawer removes without anybody noticing.
- Ovens — A wall oven in a tower is trimmed into a cabinet run with the building behind it, so removing it is planned rather than improvised, and the association usually wants notice before it happens.
- Burner will not stay lit
- Gas smell in the kitchen
- French top heats unevenly
- Grill or teppanyaki not heating
- Induction shows E2 and shuts off
How a visit in Hollywood is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- In a building: the service elevator window, the loading bay and the hours contractors are allowed to work
- Behind a gate: how visitors are cleared, arranged before the appointment rather than at it
- Whether the gas is propane or natural, which decides the orifices and the parts that ride in the van
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Hollywood are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Hollywood
Do you cover Hollywood?
Yes. Hollywood is in Broward County and inside the area we work every week. Give us the address when you book, and say how the La Cornue is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Hollywood?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Hollywood?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
My building has rules about service calls. What do you need?
The building name when you book, and anything it requires — a service elevator window, a loading bay slot, approved hours or a certificate of insurance. We arrange those in advance; found out on the day, they cost the appointment.
Booking a visit in Hollywood
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards