Repair cost
La Cornue appliance installation cost
On this equipment installation is commissioning: gas and electrical to the maker's own requirements document, leveling to a specification, a hood duct measured rather than assumed, and a first-use check across every module.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in cooking appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $295
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 614-3699
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Which size
A Castel 60 and a Grand Palais 180 are the same job on paper and not in a corridor. Weight and access set the labor.
-
Fuel and altitude
Specified at order time. A range built for natural gas and fed propane is a problem created on installation day, and above 2,000 feet a Château needs specifying.
-
The hood and its duct
600 CFM assumes an unobstructed six-inch duct. A run that cannot deliver it is measured and reported before the hood goes up.
-
What the room already has
An existing gas line, an existing circuit and an existing duct are three things that may or may not meet the specification.
-
Whether anything has to be built
A rangetop drops into a counter; a Tourelle goes into a cutout. Neither is our carpentry, and we say what is needed before the day.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $295 Appliance installation
A Château is delivered in a crate that can weigh 1,320 lb and is leveled to a specification, not to a spirit level held by eye. Installation covers gas, electrical, leveling, hood duct and the first-use check — and it covers the paperwork, because altitude, fuel type and voltage are specified at order time and have to match what is actually in the house.
- Gas and electrical to the maker's own requirements document
- Leveled to specification — a dish of water sits at one depth all over
- First-use check, and the hood duct measured rather than assumed
In more detail
About La Cornue appliance installation cost
The part of installation that nobody prices
Leveling. It sounds like the trivial step and it is the one that produces cooking complaints six months later. La Cornue gives these ranges adjustable legs and a specified height range, and its own guide gives the test: a dish of water on an oven shelf should sit at one depth all over. A range that was slid into place and connected has a vaulted oven cooking unevenly, a plaque with heat pooling to one side, and an owner who thinks their oven is faulty. Ten minutes on installation day, or a diagnostic visit later.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about La Cornue appliance installation cost
The dealer is delivering it. Do I need you as well?
Delivery and installation are different jobs and on this equipment the difference matters. A delivery puts the crate in your kitchen. Commissioning connects it to the maker's specification, levels it within its specified height range, proves the level with water on a shelf, checks every burner and both ovens, and leaves you a record of the fuel it is set for. Ask your dealer which of those two they are doing.
Can you install a range you did not supply?
Yes, and most of what we install we did not supply. What we ask for is the order paperwork if it exists — fuel type, voltage, altitude, finish reference — because those are specified at the factory and there is no way to read them off the appliance later.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name