Broward · South Florida
La Cornue repair in Lighthouse Point
Canal-front houses, many with a dock and an outdoor kitchen behind the seawall. Anything installed outdoors here takes the heat and the salt together.
We cover Lighthouse Point and the rest of Broward: an on-site diagnostic first, the price agreed in writing before anything is opened, and the exact figure confirmed once we have seen the unit.
By unit
What we repair in Lighthouse Point, by La Cornue unit
Start with whichever matches yours. How an appliance is installed shapes the visit as much as the repair does, which is why we ask about it when you book.
-
Dual fuel · gas · all-induction — Château, Châtelet, Castel, Grand Palais, CornuFé La Cornue range repair in Lighthouse Point
The range is what La Cornue makes, and everything else in the line exists around it. A Château is built to order in France, arrives in a crate weighing over half a ton, and is assembled from parts a customer chose one at a time: which oven is gas and which is electric, whether the top carries a French top, a lava-rock grill, induction or a teppanyaki plate, which of about fifty enamels, which trim metal. Two of them are almost never identical. That is the first thing a repair on one has to take seriously — the model number tells you the size, and the configuration code tells you what is actually under the lids.
- Dual fuel, all gas or all induction — three different ranges, three parts lists
- The configuration code, not just the model, decides what is on the top
- Made-to-order enamel and trim are part of the job, not an extra
-
Vaulted ovens and convection ovens — gas, electric, and the Tourelle wall oven La Cornue oven repair in Lighthouse Point
There are three different ovens on this make and they fail in three different ways. The vaulted gas oven cooks by radiant heat inside a sealed dome and has an electric broiler over it. The vaulted electric oven sits on the other side of the same range. And since 2025 there is a standalone one: the Château Tourelle, a fully electric multifunction wall oven in 60 and 75 centimeter widths, built to sit in a cabinet run next to a Château cooktop. Which of the three you have decides everything about the repair.
- Vaulted gas, vaulted electric and the electric Tourelle wall oven
- Gas ovens carry an electric broiler — browning and baking can fail separately
- Thermostat drift is measured against a probe, never adjusted by feel
-
Brass gas burners · plaque coup de feu · lava-rock grill · induction · teppanyaki La Cornue cooktop repair in Lighthouse Point
A La Cornue cooktop is a set of modules chosen at order time and dropped into a stainless frame: brass gas burners at 17,000 and 7,500 BTU, a 22,000 BTU power burner, the cast-iron plaque coup de feu heated by a single burner underneath, a lava-rock grill, ceramic-glass induction zones, an electric teppanyaki plate. This is the top of a range, and each module is a different repair. Sold on its own without ovens beneath it, the same top is a rangetop, and it has its own page.
- Gas, induction, French top, grill and teppanyaki modules on one frame
- Induction is the only half of this line that shows a code — E2, U400, Er
- A cracked glass hob is disconnected first and diagnosed second
-
T40 to T48 · 200 mm into the counter · the same modules, no ovens beneath La Cornue rangetop repair in Lighthouse Point
A rangetop is the top half of a La Cornue sold in its own right: the same brass burners, the same plaque coup de feu, the same grill, induction and teppanyaki modules, in a stainless frame 200 mm deep that drops into a counter with nothing underneath it. T40 through T48, from 600 to 1800 mm wide. Every cooktop repair applies to it and no oven repair does — which makes it the simplest appliance in the line and the one most often confused with the range on a booking.
- T40 to T48 — the same configuration codes as the range
- No ovens, no oven thermostats, no door seals
- Much lighter than a range, so the one job that prices weight rarely applies
-
Château motorized hoods H11–H20 · island hoods · inserts · CornuFé Cascade, Euclid, Loge, Marquee La Cornue range hood repair in Lighthouse Point
The hood over a La Cornue is not an accessory bought to match. A motorized Château hood starts at $17,400 for the 90 and runs past $25,000 for the Grand Palais 180, it is made in the same enamels and trims as the range, and it does real work: a 600 CFM blower on a four-speed variable motor, baffle filters with a grease capture system, three 20-watt lights and a remote. When one stops, the kitchen it was built for stops working properly.
- Motorized Château hoods, island hoods and inserts, plus the CornuFé collection
- 600 CFM blower, four-speed variable motor, baffle filters, remote control
- A hood is finished to match the range — the enamel is part of the repair
By job
The repairs we are called out for in Lighthouse Point
Starting figures for this equipment in South Florida. What moves them is the model, the access and the part — the exact cost is confirmed after the on-site diagnostic.
-
from $245 French top service
The plaque coup de feu is a single cast-iron plate heated by one 7,500 BTU burner directly under its center, and it is the most-used and least-understood part of the range. Cracks, warping, rust, dead cold spots and a burner running wrong underneath are all different problems that present the same way.
- Crazing in the seasoning and a crack through the iron are told apart
- The burner beneath it checked first — most cold spots start there
- Re-seasoned properly, so the plate is handed back working
-
from $165 Hood lighting and remote repair
Three 20-watt high-intensity lamps on the Château hoods, LEDs on the newer inserts, and two separate control paths — in-hood activation and a remote. A hood that answers its own buttons but not the remote is a receiver, not a motor.
- Single lamps are often a customer job and we say so
- Remote and in-hood controls tested as separate paths
- Two or three lamps out at once is a socket or supply problem, not bulbs
-
from $235 Convection fan repair
The electric and multifunction ovens use a fan, and the noise it makes changes as the oven heats — which the manual says is normal. A fan that rumbles, ticks, slows or stops is not normal, and it takes the oven's evenness with it.
- Bearing noise separated from the normal change in note
- Motor tested at temperature, because that is when it fails
- Blade and housing checked for the contact that causes ticking
-
from $265 Enamel panel and trim service
Vitreous enamel is glass fused to steel and about fifty colors of it were available at order time. A chip is not cosmetic in this climate — the steel under it rusts outwards — and a tarnished brass handrail attacked with the wrong product loses its lacquer along with the tarnish.
- Chips stabilized or the part ordered in the range's own color reference
- Brass, copper, nickel and chrome trim treated by what they actually are
- Clear-coated finishes identified before anything is polished
-
from $155 Surface burner and igniter service
Clicking with no flame, a burner that lights and will not stay lit, a lazy yellow flame. On brass burners in a coastal kitchen these are three symptoms of a short list of causes, and none of them is the ignition module when only one burner is affected.
- One burner out is the electrode or the ports — not the module
- Yellow flame is air mix, fuel or an orifice, and it is measurable
- Ports cleared properly rather than poked at
-
from $285 Hood blower and capacitor repair
One 600 CFM blower on a four-speed variable motor, and on the larger motorized hoods two of them. A blower that has started to rumble will eventually stop, usually on the day the kitchen is full — and where there are two, one can fail silently while the other carries the load.
- Rumble and vibration treated as a failing bearing, not a quirk
- Capacitor tested before the motor is condemned
- On a two-motor hood, both are tested — one can fail unnoticed
Nearby
Where else we work near Lighthouse Point
Every place below has its own page, with what the equipment and the access are like there.
Elsewhere in Broward
In more detail
La Cornue repair in Lighthouse Point, in more detail
What La Cornue equipment is like in Lighthouse Point
Canal-front houses, many with a dock and an outdoor kitchen behind the seawall. Anything installed outdoors here takes the heat and the salt together.
Lighthouse Point sits in Broward County, and the equipment here follows the housing: older kitchens with appliances fitted into openings that were cut for something else, and newer ones where they were specified with the cabinetry. Both are La Cornue work — cooktops and rangetops, ovens, range hoods — and both are diagnosed on site before anything is priced.
Salt, heat and storms — what they do to burners and vents
Close to the water it is the steel and the ignition that go first. Salt reaches burner caps, grates and igniter electrodes, and an igniter that has to spark through corrosion is an igniter that clicks and does not light. Ventilation suffers with it: a hood that pulls salt air through its motor every day is on a shorter life than the one the manufacturer costed. In Lighthouse Point that is the difference between an annual clean and a seasonal one.
What that means for the appliances in Lighthouse Point
- Range hoods — An outdoor hood ducts into weather rather than out of a wall, and the cap is the part that goes — usually silently, so the first sign is smoke that stays under the roof.
- Ranges — Anything cooking outdoors here spends nine months working against ambient heat that indoor equipment never sees, which shortens the life of every ignition component on it.
- Cooktops and rangetops — An outdoor cooking surface takes the summer and the salt together, and it is the equipment that most reliably needs attention before the season it was bought for.
- Oven door will not seal
- Stiff or stuck burner knob
- Oven cooks unevenly
- Gas smell in the kitchen
- Oven runs hot
How a visit in Lighthouse Point is arranged
We ask for the model number from the plate inside the door and a line about what the appliance is doing. That decides which parts ride in the van, and it is the difference between one appointment and two.
- In a building: the service elevator window, the loading bay and the hours contractors are allowed to work
- Behind a gate: how visitors are cleared, arranged before the appointment rather than at it
- Whether the gas is propane or natural, which decides the orifices and the parts that ride in the van
- The diagnosis first, then the scope and the price in writing, and your approval before anything is opened
What it costs, and what moves the figure
Prices in Lighthouse Point are the same as everywhere else we cover: a diagnostic from $95 that is credited toward the repair, and starting figures per job rather than one number for "a repair". What moves it is the model, how the appliance is built into the cabinetry, which part it needs and how quickly that part can be sourced — none of which can be judged over the phone. The repairs we carry out lists what each job involves and the figure it starts at, and the unit pages covers what tends to go wrong on each type.
The exact cost is confirmed after the on-site diagnostic and agreed with you before any work begins. We are an independent repair company — not affiliated with, authorized by, or endorsed by any manufacturer — and our warranty covers the labor we performed.
Before you book
Questions about a visit in Lighthouse Point
Do you cover Lighthouse Point?
Yes. Lighthouse Point is in Broward County and inside the area we work every week. Give us the address when you book, and say how the La Cornue is installed — what has to come apart to reach it matters as much as where it is.
How soon can you get to Lighthouse Point?
We will tell you the earliest slot we can genuinely keep rather than the earliest one that sounds good. Tell us the model number and what the unit is doing when you book: whether we can finish the same day depends on the part far more than on the drive.
Does it cost more because the job is in Lighthouse Point?
No. The diagnostic and the work are priced the same across Miami-Dade, Broward and Palm Beach. What moves the figure is the model, how the unit is built in and which part it needs — never the address. Where access takes longer, we say so before anything is agreed rather than after.
Does being this close to the water shorten the life of a unit?
It shortens the life of the condenser and the fan motors, which is not the same thing. Salt corrodes them years ahead of the schedule written for a dry climate, and a condenser that cannot shed heat makes the compressor work longer for the same result. Cleaning here is seasonal rather than annual.
Booking a visit in Lighthouse Point
Tell us the model number and what the unit is doing. We will bring the parts that problem usually needs, and you will have a firm price before we start.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards